Power-on/off checking the battery level, Power-on/off, Checking the battery level – Nikon Coolwalker User Manual
Page 20
10
Pr
ep
ar
at
io
n
—
Po
w
er
-O
N
/O
FF
Power-ON/OFF
To power the MSV-01 on, press and hold down the power switch (
3) for about 2 seconds. The
monitor will turn on showing the welcome screen, then it will switch to the main menu. To turn
the MSV-01 off, press and hold down the power switch for about 2 seconds when the power-on
lamp is on.
The MSV-01 status is shown as follows:
Turning the Power On/Off
• Be sure to turn the MSV-01 off, when:
- inserting or removing a memory card;
- connecting or disconnecting the A/V cable;
- removing the battery pack.
• The MSV-01 will not go off if the power switch is pressed while the copy (
memory card format (
55) operation is in progress and "Copying..." or "Formatting..." is
displayed on the monitor.
Auto Power Off
If no operation is performed for one minute (default setting) when running on battery power, the MSV-
01 will turn off automatically.
• This setting can be changed using the Auto power off option in the SET UP menu (
54).
• The Auto power off function is disabled when the MSV-01 is running on the AC power supply.
Checking the Battery Level
The battery status is displayed at the bottom of the MSV-01 monitor.
During operation, the display may temporarily indicate a lower than the actual remaining battery
charge.
Using the MSV-01 from an AC Power Source
To power the MSV-01 continuously for extended periods, use the DSA-0151F-05 AC adapter. Do not,
under any circumstances, use another make or model of an AC adapter. Failure to observe this
precaution could result in overheating or in damage to the MSV-01.
Power-on Lamp
COOLWALKER MSV-01
ON (green)
Power ON
OFF
Power OFF
Blinking (orange)
Charging (OFF)
On (orange)
Charging completed (OFF)
Display
Description
Battery is fully charged.
Battery power is low. The power may go off dur-
ing operation.
Battery is exhausted. Recharge or use the AC
adapter immediately.
Not displayed
The MSV-01 is operating from an AC power
source.
Power switch
Power-on lamp
Battery status