Nikon COOLPIX-P100 - Manual (Page 177)

165
Setup Menu
B
asi
c C
am
e
ra S
e
tup
i Sound Settings
Adjust the following sound settings.
k Auto Off
If no operations are performed for the selected length of time, the monitor will turn
off and the camera enters standby mode (
A21) to reduce drain on the batteries.
The power-on lamp blinks in standby mode. If no operations are performed for
another three minutes, the camera will turn off.
Choose the time allowed to elapse before the camera enters standby mode if no
operations are performed from 30 s, 1 min (default setting), 5 min, and 30 min.
C
Canceling Standby Mode
Standby mode is canceled when the following buttons are pressed.
• Power switch
• Shutter-release button
•
c button
The standby mode can also be canceled by rotating the mode dial.
B
Notes on Auto Off
The time taken for the monitor to enter standby mode is as follows.
• When menus are displayed: three minutes
• During slideshow playback: maximum of 30 minutes
• When the AC adapter EH-62A is connected: 30 minutes
Press the
d button M z (Setup menu) (A153) M Sound settings
Button sound
Turn button sound On (default setting) or Off. A beep will sound once when the
settings are completed successfully, twice when the camera focuses on the subject,
and three times when an error is detected. Start-up sound will also play when the
camera is turned on.
Shutter sound
Choose shutter sound from On (default setting) or Off.
• Even when On is set, the shutter sound is not made during continuous shooting
or movie recording.
Press the d button M z (Setup menu) (A153) M Auto off