Troubleshooting, Display, settings and power supply – Nikon L310 User Manual
Page 148

136
Techn
ic
al Not
es
Troubleshooting
If the camera fails to function as expected, check the list of common problems
below before consulting your retailer or Nikon-authorized service representative.
Refer to the page numbers in the right-most column for more information.
Display, Settings and Power Supply
Problem
Cause/Solution
A
Monitor is blank
• Camera is off.
• Battery exhausted.
• Standby mode for saving power: Press the
power switch, shutter-release button, A
button,
c button, or b (e movie-record)
button
• When flash lamp flashes red, wait until flash
has charged.
• Camera and computer are connected via USB
cable.
• Camera and TV are connected via audio/video
cable.
Monitor is hard to read
• Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
Camera turns off without
warning
• Battery exhausted.
• Camera has turned off automatically to save
power.
• Battery is cold.
Date and time of recording are
not correct
• Images captured while the clock is not set will
have a time stamp of “00/00/0000 00:00”;
movies will be dated “01/ 01/2012 00:00”. Set
the correct date and time using Time zone
and date in the setup menu.
• Check camera clock regularly against more
accurate timepieces and reset as required.
No indicators displayed in
monitor
Hide info is selected for Photo info.
Select Show info.
Print date not available
Camera clock has not been set.
Date not imprinted on images
even when Print date is
enabled.
• Print date cannot be used with the current
shooting mode.
• Print date cannot be used when recording
movies.
Screen for setting date and time
is displayed when camera is
turned on.
The clock battery is exhausted; all settings were
restored to their default values.
Camera settings reset.