Savin 4800WD - Manual (Page 17)

7
1. Basics
Before Copying
Before you start copying, specify the original and copy paper locations.
❖ ❖ ❖ ❖ Paper Capacities For Each Original/Paper Output
Original output Capacities
Original Exit : Top A1 (D) L or smaller: 50 sheets (plain paper)
20 sheets (translucent paper)
• Use originals that are the same size, and of medium or high qual-
ity paper.
• Do not use paper that is long length paper, thick, curled, film,
folded, or translucent paper that is less than 80 g/m 2 (21.3 lb) in
weight.
• Do not load more than 10 sheets during very hot or humid con-
ditions.
• Output thick paper (104.7 g/m 2 (27.9 lb) or more) to Rear (Straight).
• Translucent paper: 80 g/m 2 (21.3 lb) or less, plain paper: 52.3
g/m 2 (13.9 lb) or less, and originals that are not stiff should be
output to Rear (Straight).
Original Exit : Rear
(Straight) A0 (E) K or smaller: 1 sheet (plain paper)
1 sheet (translucent paper)
1 sheet (film)
• When output originals of A1 (E) K or larger, the ejected originals
may interfere with the copy paper and impede its progress. If this
happens, use the copy output (rear) auxiliary guide.
• When copying A0 (E) Ksize originals, remove them one by one.
Original Exit : Rear
(document roller) A1 (D) Lor larger: 1 sheet (up to 6 m (236")) (plain
paper)
1 sheet (up to 3.6 m (141")) (trans-
lucent paper)
1 sheet (up to 3.6 m (141")) (film)
• Use face-curl originals.
• For roll originals, use originals with a diameter of roll Φ40 mm –
Φ110 mm (Φ1.6" – Φ4.3").
• Do not use the document roller when copying on originals of size
longer than the maximum length for each paper type. Use both
hands to roll the original.
DolphinC2_ENcopy_F_FM.book Page 7 Friday, February 25, 2005 10:46 AM