Allied Telesis AT-WCU200G - Manual (Page 36)

22
❑ Tx Rate: Indicates the data transfer rate between the node and
another device. The default is Auto. The Tx Rate is determined by
the AT-WCU200G wireless adapter automatically, depending on
the distance to the access point or wireless router.
2. Click Okay.
Setting Encryption
This section discusses how to set the following authentication and
encryption modes:
❑ WEP (Wired Equivalent Privacy)
❑ WPA (Wi-Fi Protected Access)
❑ WPA-PSK (Wi-Fi Protected Access and Private Shared Key)
❑ TLS (Transport Layer Security protocol)
❑ PEAP (Protected Extensible Authentication protocol)
❑ TKIP (Temporal Key Integrity Protocol)
❑ AES (Advanced Encryption Standard encryption mode)
For more information about the authentication and encryption modes,
see
Configuring Wireless Network Authentication Settings on page 35
and Data Encryption on page 36.
To display the Profile Edit screen, see Configuring Network Profiles on
page 18. This screen is displayed in Figure 17 on page 20.
To set the encryption mode for the AT-WCU200G wireless adapter,
perform the following procedure:
1. Click the following icon at the bottom right hand corner of your
screen.
The Allied Telesyn Wireless Client Manager screen is displayed with
the Status Tab selected. See Figure 15 on page 13.