Allied Telesis AT-S82 - Manual (Page 28)

Chapter 3: Port Configuration
28
Configuring Port Parameters
This procedure explains how to configure the following port parameters:
ˆ State
ˆ Speed and duplex mode
ˆ Flow control
ˆ Medium type (only for ports 7 and 8)
To configure the ports, perform the following procedure:
1. From the main menu, select Port Configuration.
The Port Configuration page is shown in Figure 11.
Figure 11. Port Configuration Page
The top part of the page allows you to select port(s) and apply
configuration parameters. The bottom part shows the current
configuration.
Ports 7 and 8 are listed twice, once as a twisted pair port (copper) as
ports 7R and 8R, and once as an SFP (fiber) port as ports 7 and 8.
This allows you to see if the port is operating as a twisted pair or SFP
port, or if the ports are operating in combo fashion.