Allied Telesis AT-S82 User Manual
Management software, User’s guide
Table of contents
Document Outline
- Contents
- Figure 1. Login Dialog Box 12
- Figure 2. Main Page 13
- Figure 3. Save Configuration Page 14
- Figure 4. Basic Switch Information Page 18
- Figure 5. Administrator Password Page 22
- Figure 6. Reboot Page 23
- Figure 7. Reset Page 24
- Figure 8. Reset System Page 25
- Figure 9. Download Firmware Page 26
- Figure 10. Download Status Message 26
- Figure 11. Port Configuration Page 28
- Figure 12. Trunking Algorithm Page 34
- Figure 13. Port Trunking Page 35
- Figure 14. Port Trunking Configuration Page 35
- Figure 15. 802.1Q Static VLAN Page 43
- Figure 16. VLAN Detail Page 43
- Figure 17. Current VLANs Page 45
- Figure 18. Protected Ports VLAN Example 46
- Figure 19. Protected Port Page for Figure 18 46
- Figure 20. Protected Port Page 47
- Figure 21. CoS Priority to Queue Page 53
- Figure 22. Output Scheduling Page 54
- Figure 23. CoS Port Priority Assignment Page 55
- Figure 24. Point-to-Point Ports 63
- Figure 25. Edge Port 64
- Figure 26. Point-to-Point and Edge Port 64
- Figure 27. VLAN Fragmentation 65
- Figure 28. Switch Spanning Tree Settings Page 67
- Figure 29. STP Port Settings Page 70
- Figures
- Preface
- Chapter 1
- Getting Started
- Chapter 2
- Basic Switch Parameters
- Configuring the IP Address, Subnet Mask, Gateway Address, and BOOTP or DHCP
- Disabling or Enabling Ping Blocking
- Enabling or Disabling 802.1X Forwarding Control
- Changing the Administrator’s Password
- Rebooting the Switch
- Resetting the Switch and Retaining the IP Address
- Returning the AT-S82 Management Software to the Factory Default Values
- Downloading New Firmware
- Chapter 3
- Port Configuration
- Chapter 4
- Trunking
- Chapter 5
- VLANs
- Chapter 6
- Class of Service
- Chapter 7
- Spanning Tree Protocol (STP)