Allied Telesis AT-FS717FC/SC - Manual (Page 33)

AT-FS717FC/SC Fast Ethernet Switch Installation Guide
33
Wall-Mounting the Switch
The switch can be mounted horizontally on a wall using the two keyhole
slots in the bottom of the switch.
To mount an AT-FS717FC/SC switch onto a wall, perform the following
procedure:
1. Remove all equipment from the package and store the packaging
material in a safe place.
2. If attached, remove the rubber feet, data cables, and power cord from
the switch.
3. Select a wall location for the switch.
4. Mark two hole locations on the wall.
5. At the marked locations for the holes, pre-drill for the drywall anchors
and drive the screws through the holes.
6. Align the switch horizontally, as illustrated in Figure 10.
Figure 10. Aligning an AT-FS717FC/SC for Wallmount Installation
1138