Allied Telesis AT-FS202SC/FS1 - Manual (Page 37)

AT-FS20x Series Installation Guide
27
ˆ You should check to be sure that you are using the appropriate
type of twisted pair cabling. Refer to Table 3 on page 18 for
twisted pair cable specifications.
ˆ Since the twisted pair port, when operating in Auto-Negotiation, is
Auto MDI/MDI-X, you can use either a straight-through or
crossover twisted pair cable to connect any type of network
device to a port on the converter. If you disable Auto-
Negotiationon the port, the port default to MDI-X.
10. Power ON the end-nodes.
11. Verify that the LNK/ACT LEDs for both the fiber optic port and the
twisted pair port are green. If either LED is OFF, refer to
“Troubleshooting” on page 31 for instructions.