Allied Telesis AT-S63 - Manual (Page 696)

Chapter 42: TACACS+ and RADIUS Commands
696 Section IX: Management Security
ADD RADIUSSERVER
Syntax
add radiusserver server|ipaddress= ipaddress order= value
[secret= string ] [port= value ] [accport= value ]
Parameters
server or Specifies an IP address of a RADIUS server. The
ipaddress parameters are equivalent.
order Specifies the order that the RADIUS servers are queried by
the switch. This value can be from 1 to 3. The servers are
queried starting with 1.
secret Specifies the encryption key used for this server. The
maximum length is 39 characters.
port Specifies the UDP (User Datagram Protocol) port of the
RADIUS server. The default is port 1812.
accport Specifies the UDP port for RADIUS accounting. The default
is port 1813.
Description
This command specifies the IP addresses of the RADIUS servers and the
order they are to be queried by the switch. There can be up to three
servers, but you can specify only one at a time with this command. You
may specify an encryption key, a RADIUS UDP port, and a RADIUS
accounting UDP port.
Note
The switch must have a routing interface on the local subnet where
the authentication server is a member. The switch uses the IP
address of the interface as its source address when sending packets
to the server. For instructions on how to add a routing interface to
the switch, refer to “ADD IP INTERFACE” on page 548.
Examples
The following command adds a RADIUS server with the 149.245.22.22 IP
address and specifies it as the first server in the list:
add radiusserver ipaddress=149.245.22.22 order=1