Allied Telesis AT-S63 - Manual (Page 351)

AT-S63 Management Software Command Line Interface User’s Guide
Section III: Snooping Protocols 351
SHOW IGMPSNOOPING
Syntax
show igmpsnooping
Parameters
None.
Description
This command displays the IGMP parameters. Figure 30 illustrates the
information that is displayed by this command.
Figure 30. SHOW IGMPSNOOPING Command
For an explanation of these parameters, refer to “SET IP IGMP” on
page 348 and “SHOW IP IGMP” on page 353.
IGMP Snooping Configuration:
IGMP Snooping Status ............... Disabled
Host Topology ...................... Single-Host/Port (Edge)
Host/Router Timeout Interval ....... 260 seconds
Maximum IGMP Multicast Groups ...... 64
Router Port(s) ..................... Auto Detect
Router List:
VLAN Port/Trunk ID RouterIP
----------------------------------------------------
1
14/- 172.16.01.1
Host List:
Number of IGMP Multicast Groups: 4
VLAN Port/ IGMP Exp.
MulticastGroup ID TrunkID HostIP Ver Time
------------------------------------------------------------
01:00:5E:00:01:01 1 6/- 172.16.10.51 v2 21
01:00:5E:7F:FF:FA 1 5/- 149.35.200.75 v2 11
149.35.200.65 v2 65
01:00:5E:00:00:02 1 17/- 149.35.200.69 v2 34
01:00:5E:00:00:09 1 14/- 172.16.10.51 v2 32