Allied Telesis AT-S63 - Manual (Page 598)

Chapter 34: Virtual Router Redundancy Protocol (VRRP) Commands
598 Section II: Advanced Operations
CREATE VRRP
Syntax
create vrrp= vrid over= interface ipaddress= ipaddress
[adinterval=1...255] [authentication=none|plaintext]
[password=
password ] [portmonitoring=on|off]
[portreset=on|off] [preempt=on|off] [priority=1..254]
[stepvalue=1..254|proportional] [delay=0..3600]
Parameters
vrrp Specifies the ID of the virtual router, a number
between 1 and 255.
over Specifies the interface over which the virtual router
will send and receive packets. An interface name
consists of “VLAN” followed by the name or ID (VID)
of the VLAN and the interface number (e.g., vlan-
Sales-0 or vlan4-0).
ipaddress Specifies a secondary IP address to be backed up by
the specified virtual router. The IP address must be
compatible with the IP address and subnet mask
associated with the Ethernet interface over which the
virtual router is operating.
adinterval Specifies the interval in seconds between
advertisement packets. The range is 1 to 255
seconds and the default is 1 second. You must
configure all switches in the same virtual router with
the same adinterval.
authentication Specifies whether there is authentication. Options
are:
none Specifies no authentication. This is the
default setting.
plaintext Specifies that authentication is required,
which you set with the password
parameter.
password Specifies the password used to authenticate VRRP
packets. The password can be up to 8 alphanumeric
characters. The password is case sensitive and can
include the hyphen and underscore.
Passwords are sent in plaintext. The AT-S63
Management Software does not support encrypted