Allied Telesis AT-2911 Series Adapters - Manual (Page 33)

AT-2911 Series Gigabit Ethernet Network Adapters Installation and User’s Guide
33
Replacing the Bracket
The AT-2911 series adapter is shipped with the low-profile bracket
attached to the adapter. Depending on your PC, you may need to replace
the bracket attached to your adapter.
The following procedure describes how to remove the low-profile bracket
from the adapter and replace it with the standard bracket. You can also
use this procedure to remove the standard bracket and replace it with the
low-profile bracket.
To replace the low-profile bracket with the standard bracket, perform the
following procedure:
1. Remove the screws that attach the bracket to the adapter. See
Figure 9.
Figure 9. Removing the Low-Profile Bracket