Allied Telesis AT-2900 Series Adapters - Manual (Page 130)

Chapter 11: DOS Diagnostics
130
/* 34 */ "Cannot TX Packet!",
/* 35 */ "Requested to Tx %d. Only %d is transmitted",
/* 36 */ "Expected %d packets. Only %d good packet(s) have
been received\n%d unknown packets have been received.\n%d
bad packets have been received.",
/* 37 */ "%c%d is an invalid Test",
/* 38 */ "EEPROM checksum error",
/* 39 */ "Error in reading WOL/PXE",
/* 40 */ "Error in writing WOL/PXE",
/* 41 */ "No external memory detected",
/* 42 */ "DMA buffer %04X is large, size must be less than
%04X",
/* 43 */ "File size %d is too big, max is %d",
/* 44 */ "Invalid %s",
/* 45 */ "Failed writing 0x%x to 0x%x",
/* 46 */ "",
/* 47 */ "Ambiguous command",
/* 48 */ "Unknown command",
/* 49 */ "Invalid option",
/* 50 */ "Cannot perform task while chip is not running.
(need driver)",
/* 51 */ "Cannot open register define file or content is
bad",/* 52 */ "ASF Reset bit did not self-cleared",
/* 53 */ "ATTN_LOC %d cannot be mapped to %cX CPU event bit
%d",
/* 54 */ "%s Register is not cleared to zero after reset",
/* 55 */ "Cannot start poll_ASF Timer",
/* 56 */ "poll_ASF bit did not get reset after
acknowledged",
/* 57 */ "Timestamp Counter is not counting",
/* 58 */ "%s Timer is not working",
/* 59 */ "Cannot clear bit %s in %cX CPU event register",
/* 60 */ "Invalid "EEPROM_FILENAME" file size, expected %d
but only can read %d bytes",
/* 61 */ "Invalid magic value in %s, expected %08x but
found %08x",
/* 62 */ "Invalid manufacture revision, expected %c but
found %c",
/* 63 */ "Invalid Boot Code revision, expected %d.%d but
found %d.%d",
/* 64 */ "Cannot write to EEPROM",
/* 65 */ "Cannot read from EEPROM",
/* 66 */ "Invalid Checksum",
/* 67 */ "Invalid Magic Value",
/* 68 */ "Invalid MAC address, expected %02X-%02X-%02X-
%02X-%02X-%02X",