Allied Telesis AT-2900 Series Adapters - Manual (Page 129)

AT-2900 Series Gigabit Ethernet Network Adapters Installation Guide
129
Error Messages
/* 0 */ “PASS”,
/* 1 */ “Got 0x%08X @ 0x%08X. Expected 0x%08X",
/* 2 */ 'Cannot perform task while chip is running",
/* 3 */ "Invalid NIC device",
/* 4 */ "Read only bit %s got changed after writing zero
at offset 0x%X",
/* 5 */ "Read only bit %s got changed after writing one at
offset 0x%X",
/* 6 */ "Read/Write bit %s did not get cleared after writing
zero at offset 0x%X",
/* 7 */ "Read/Write bit %s did not get set after writing
one at offset 0x%X",
/* 8 */ "BIST failed",
/* 9 */ "Could not generate interrupt",
/* 10 */ "Aborted by user",
/* 11 */ "Tx DMA:Got 0x%08X @ 0x%08X. Expected 0x%08X",
/* 12 */ "Rx DMA:Got 0x%08X @ 0x%08X. Expected 0x%08X",
/* 13 */ "Tx DMA failed",
/* 14 */ "Rx DMA failed",
/* 15 */ "Data error, got 0x%08X at 0x%08X, expected
0x%08X",
/* 16 */ “Second read error, got 0x%08X at 0x%08X, expected
0x%08X",
/* 17 */ "Failed writing EEPROM at 0x%04X",
/* 18 */ "Failed reading EEPROM at 0x%04X",
/* 19 */ "EEPROM data error, got 0x08X at 0x04X, expected
0x%08X",
/* 20 */ "Cannot open file %s",
/* 21 */ "Invalid CPU image file %s",
/* 22 */ "Invalid CPU image size %d",
/* 23 */ "Cannot allocate memory",
/* 24 */ "Cannot reset CPU",
/* 25 */ "Cannot release CPU",
/* 26 */ "CPU test failed",
/* 27 */ "Invalid Test Address Range\nValid NIC address is
0x%08X-0x%08X and exclude 0x%08X-0x%08X",
/* 28 */ "DMA:Got 0x%08X @ 0x%08X. Expected 0x%08X",
/* 29 */ "Unsupported PhyId %04X:%04X",
/* 30 */ "Too many registers specified in the file, max is
%d",
/* 31 */ "Cannot write to VPD memory",
/* 32 */ "VPD data error, got %08X @ 0x04X, expected %08X",
/* 33 */ "No good link! Check Loopback plug",