Samsung LE32M87BD - Manual (Page 57)

english -
Setting up anynet+
the following settings are to use anynet+ functions.
using the anynet+ Function
1. Press the anynet+ button.
Press the ▲ or ▼ button to select Setup, then press the
enter/oK button.
2. Press the enter/oK button to select anynet+ (hDmI-CeC),
then press the enter/oK button.
. Press the ▲ or ▼ button to select on, then press the enter/
oK button.
The Anynet+ (HDMI-CEC) function is enabled.
If you select off, Anynet+ (HDMI-CEC) is disabled.
When the Anynet+ (HDMI-CEC) function is disabled, all the
Anynet+ related operations are deactivated.
turning an anynet+ Device off automatically when the tV is turned off
1. Press the ▲ or ▼ button to select auto turn off, then press
the enter/oK button.
2. Press the ▲ or ▼ button to select on, then press the enter/
oK button.
The Auto turn off function is enabled.
If you select off, the Auto turn off function is canceled.
Press the exIt button to exit.
The Select Device setting of the TV remote control is to be set to
TV to use the Anynet+ function.
If you set Auto Turn Off to On, connected external devices are also turned off when the TV is turned off.
However, if the device is recording, it may not be turned off.
➣
➣
➣
➣
➣
➣
➣
Scanning and Switching between anynet+ Devices
1. Press the anynet+ button.
2. Press the ▲ or ▼ button to select Select Device, then press
the enter/oK button.
. Press the ▲ or ▼ button to select to a particular device and
press the enter/oK button.
It is switched to the selected device.
. If you cannot find a device you want, press the ▲ or ▼ button
to select Searching Connections, then press the enter/oK
button.
The meassage Configuring anynet+ connection... is
displayed. When searching devices completes, the connected
devices are listed in the Anynet+ menu.
Switching to the selected devices may take up to 2 minutes. You
cannot cancel the operation during the switching operation.
The time required to scan for devices is determined by the number
of connected devices.
When the device scan is complete, the number of found devices
is not displayed.
Although the TV automatically scans devices when it is turned on
using the PoWer button, devices connected when the TV is on or under a specific circumstance are not
displayed in the device list. Therefore select Searching Connections menu to search devices.
If you have selected external input mode by pressing the SourCe button, you cannot use the Anynet+
function. Make sure to switch to an Anynet+ device by using the anynet+ button.
➣
➣
➣
➣
➣
enter move
View tV
Select Device 
record 
menu on Device 
Device operation 
receiver :off 
Setup 
air 2
exit
Setup
anynet+ (hDmI-CeC) : off
auto turn off : off
Searching Connections
enter return move
off
on
Setup
anynet+ (hDmI-CeC) : on
auto turn off : off
Searching Connections
enter return move
off
on
Setup
anynet+ (hDmI-CeC) : on 
auto turn off : on 
Searching Connections 
enter return move
enter move
View tV
Select Device 
record 
menu on Device 
Device operation 
receiver :off 
Setup 
air 2
return
DVDr1
DVDr2
DVD1
DVD2
BN68-01186H-01Eng-0523.indd 55 2007-05-23 ¿ААь 8:56:14