Checking the signal information, Upgrading the software – Samsung LE32M87BD User Manual
Page 45
english -
You can get information about the signal status.
1. Press the D.menu button to display the DTV menu.
2. Press the
▲ or ▼
button to select "Setup", then press the
enter/oK button.
. Press the
▲ or ▼
button to select "System", then press the
enter/oK button.
. Press the
▲ or ▼
button to select "Signal Information",
then press the
enter/oK button.
. Press the exIt button to exit.
If the signal status is poor, the "No signal." message is
displayed.
Checking the Signal Information
move
enter
return
Signal Information
Service: ?
Service ID:0000
multiplex: ? (tSID 0000, onID 0000)
network: ? (ID 0000)
bit error level: 10
Signal Strength: 0
return
to keep your product up-to-date with new Digital television
features then software upgrades are periodically broadcast
as part of the normal television signal.
It will automatically detect these signals and display the
software upgrade banner. You are given the option to install
the upgrade.
1. Press the D.menu button to display the DTV menu.
2. Press the
▲ or ▼
button to select "Setup", then press the
enter/oK button.
. Press the ▲ or ▼ button to select "System", then press the
enter/oK button.
. Press the ▲ or ▼ button to select "Software Upgrade",
then press the
enter/oK button.
. Press the ▲ or ▼ button to select "Software Infomation",
"Manual Upgrade" or "Satandby Mode upgrade".
Press the
enter/oK button.
Software Inforamtion
Press the
enter/oK button, then the current software
version is shown. To display the software version
information, press the
enter/oK button again.
Manual Upgrade
Press the
enter/oK button to search for new software
from the currently broadcasting channels.
Standby Mode Upgrade : On / Off
Press the
enter/oK button. To continue software
upgrade with master power on, Select On by pressing
the ▲ or ▼ button.
45 minutes after entering standby mode, a manual
upgrade is automatically conducted. Since the power
of the unit is turned on internally, the screen may be
on slightly for the LCD product. This phenomenon may
continue for more than 1 hour until the software upgrade
is completed.
. Press the exIt button to exit.
upgrading the Software
System
Product Information
Signal Information
Software upgrade
Common Interface
reset
Software upgrade
Software Information
manual upgrade
Standby mode upgrade : on
Software upgrade
Software Information
manual upgrade
Standby mode upgrade : on
Software upgrade
Software Information
manual upgrade
Standby mode upgrade : on
move
enter
return
move
enter
return
move
enter
return
move
enter
return
BN68-01186H-01Eng-0523.indd 43
2007-05-23 ¿ААь 8:56:06