Atlantis Land Mistral Lan Router ISDN - Manual (Page 47)

Example:
Router> show system
System Name: Router Up Time: 0 months 1 days 21:21:05
----------------------------------------------------------------------
system description: IP Brouter Over ISDN Line
system contact: Unknown
system location: Unknown
community string (read): public
Trap generation: Disabled
Total Serial Ports: 1 S/W Version: 1.03 H/W Version: 1.0
MAC Address: 00-60-20-10-00-70
Console Baud Rate : 19200
Console Timeout: 10(min) Learning State: Enabled
Remote Management State: Enabled
DHCP State: Enabled
IP RIP Mode: Active Ver.1
IP address: 0.0.0.0 network mask: 0.0.0.0
Private IP address: 192.168.168.230 network mask: 255.255.255.0
Enabled features: HTTP Compression SNMP Filter NAS CLI L2L Bridging
show system log
Description: The system log contains logs of various events of interest, depending on the log level set
at the time. Common events include login, a PPP connection goes up or down (log level 2), a frame
relay DLCI connection goes up or down (log level 2), … as well as certain protocol progress messages
for debugging purposes.
This command shows the next 22 entries of the system log. For example, if there are 60 entries in the
log, the first “show system log” command will show log entries 1 through 23, the next command will
show entries 24 through 46, and the next command will show entries 47 through 60, followed by 1
through 9. When the system powers up, the log is re-initialized and contains no entries. As time passes,
when the 128-entry log table becomes full, new entries will simply replace the oldest entries, thus a
first-in, first-out scheme is used.
Example:
1 Sep-03-99 16:52:48 PPP Network Protocol Event: mdm3.2 IPCP Inactivity
2 Sep-03-99 17:21:59 ISDN: ACTV REQ
3 Sep-03-99 17:22:11 ISDN: T3 Expire State = F4
4 Sep-03-99 17:22:11 ISDN: Line De-activated
5 Sep-03-99 17:27:40 ISDN: ACTV REQ
6 Sep-03-99 17:27:50 ISDN: ACTV REQ
7 Sep-03-99 17:27:52 ISDN: T3 Expire State = F4
8 Sep-03-99 17:27:52 ISDN: Line De-activated