Atlantis Land Mistral Lan Router ISDN - Manual (Page 43)

(1) Bridging (2) Compression (3) Diagnostics
(4) Filtering (5) IP (6) Port
(7) Profile (8) Security (9) SNMP
(10) Statistics (11) System
Please enter a selection number [1..11] for more detail information: 1
disable bridging
disable learning
enable bridging
enable learning
show bridging
show learning
show learning
Please enter a selection number [1..11] for more detail information:
logout
Description: This command logs the user out of the system.
reset system
Description: This command allows the user to reset the system. A confirmation will be displayed.
save config
Description: This command saves any configuration changes to the flash memory.
In the background, the system is already periodically checking to see if any configuration changes have been
made. If so, the entire configuration will be automatically saved to the flash memory. However, this command
can also be used to execute the save operation immediately after some configuration changes, e.g., when the user
intends to power down the system.
set console baud
Description: This command is used to set the baud rate for the auxiliary (console) port. The default
baud rate is 19200 bits per second. After the baud rate is changed, the console will no longer work
properly until the terminal baud rate is changed accordingly. Other allowed speeds include 115.2K,
57.6K, 38.4K, 28.8K, 19.2K, 14.4K, 9.6K, 4.8K, 2.4K, and 1.2K.
Example:
Router> set console baud 19200
set console timeout <1-60>
Description: This command is used to set the console time-out value (in minutes). The default value is
10 minutes. That means if the user does not type anything on the console for 10 minutes, the console
session will automatically be terminated.
This timeout value also applies to telnet sessions.