Atlantis Land Mistral Lan Router ISDN - Manual (Page 41)

show snmp statistics
Description: Refer to this command under SNMP Commands.
show tcp statistics
Description: Refer to this command under IP Commands.
show udp statistics
Description: Refer to this command under IP Commands.
show statistics
Description: This command displays statistical information associated with the specified profile or the
LAN.
System Commands
change password
Description: This command allows the user to change the password used to log on to the Command
Line Interface or the HTTP. A password is a character string that starts with a letter and contains at
least 6 and up to a total of 15 alphanumeric characters. The password is case sensitive. The default
factory setting is “password”.
If you forget the password, the only way to recover is clear the entire configuration and return the unit
to its original state as shipped from the factory. Unfortunately, this means that you have to re-enter all
of your configuration data.
To clear the configuration and restore the password to the default, follow these steps:
Connect a console to the Console port.
Turn off the router, then turn it on again. In the console window, you’ll see the message
“Loading firmware...”
When you see the message "Ready", immediately (within one second) press Control-C.
The router will now reset. When this is complete, the router will return all settings to the factory
default. The password will once again be “password”.
Example:
Router> change password
Please enter the old password:
Please enter the new password:
Please re-enter the new password: