Disable port enable port Page 32
Page 32
disable port
enable port
Description: These two commands is used to disable or enable a port.
⊕set port
The set port command is used to initialize or modify the characteristics of a hardware port on your
router. Hardware ports are identified by port name and are model-specific. The name “ISDN” means
the ISDN BRI interface.
π
The name “ewan” stands for Ethernet-based WAN port which is connected
to broadband modem.
P
ORT
T
YPE
: ISDN
Description: This command configures the ISDN port. For European users, select Switch Type as
“Europe (ETSI)” and configure the related parameters.
Example:
Router> set port isdn
enter switch : 1> Japan (INS Net) 2> Europe (ETSI) 3> NT DMS-100
4> NI-1 5> ATT5ESS (MP) 6> ATT5ESS (P2P)
7> Taiwan
8> OCN
9> Permanent 64K
10> IDSL/Perm 128K 0> AutoDetect, [0]: 2
How many directory numbers [DN] are assigned (1, 0-3): 2
enter Directory Number 1 [DN1] [Unspecified]: 5551111
enter Directory Number 2 [DN2] [Unspecified]: 5552222
Port isdn is configured successfully.
Router>
π
P
ORT
T
YPE
: EWAN
Description: This command is used to enable the ewan port.
Example:
Router> set port ewan
Port ewan is configured successfully.
Router>
show port
Description: This command displays the configuration information for all ports.
Example:
Router> show port
Port Name :
isdn
Port Type :
ISDN
Admin Status:
Enabled
Op State:
Down