Samsung HT-H7730WM-ZA - Manual (Page 10)

10
- English
Connections
Installing the Speakers on the Tallboy Stands
1. Find the speaker cable that is attached to the Stand.
Turn the Stand and Stand Base upside-down, unravel
the speaker cable, and then draw it through the hole
in the Stand Base.
✎ Handle the Stand carefully. It is heavy.
2. Connect the Stand Base to the bottom of the Stand.
3. Insert three 5x20 screws into the marked holes
in the Stand Base, and then tighten them with a
screwdriver as shown in the illustration.
4. Place the speaker cable into the slot on the bottom
of the stand base.
5. Connect the assembled stand and a speaker together
by matching the labels on the stand and speaker
with each other as shown in the picture.
6. Insert a screw (5x20) into the hole on the rear of the
speaker and tighten by turning it clockwise with a
screwdriver.
7. Repeat steps 1 through 6 with the other speaker and
stand.
Speaker Cable Connections
1. Match each speaker cable bundle to the correct speaker by matching the color coded plug on each
bundle to the colored sticker on the bottom or back of each speaker.
2. Connect the speaker wire plugs from each speaker to the back of the product by matching the
colors of the speaker plugs to the colors of the speaker jacks.
HDMI OUT HDMI IN 1 2
LAN
POWER
AUX IN FM ANT
OPTICAL
DIGITAL AUDIO IN
L
R
SPEAKERS OUT
CENTER SUBWOOFER
FRONT L FRONT R
FRONT TOP L FRONT TOP R
IMPEDANCE : 3
Ω
SPEAKERS OUT
CENTER SUBWOOFER
FRONT L FRONT R
FRONT TOP L FRONT TOP R
IMPEDANCE : 3
Ω
Center Speaker
Wireless Receiver Module
Surround
Speaker (L) Surround
Speaker (R)
* This product should be connected with the SWA-6000 only.
Front Top/
Front Speaker (L)
Front Top/
Front Speaker (R)
Subwoofer
1
3
5 6
4
Speaker
Stand
Stand Base
Stand
2