Samsung HMX-W200TN-XAA - Manual (Page 5)

v
Important safety instructions
13 Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as when the power supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
14. Do not expose this apparatus to dripping or splashing. Do not
place objects filled with liquids, such as vases, on the apparatus.
15. VENTILATION:
Slots and openings in the cabinet are provided for ventilation to
ensure reliable operation of the PRODUCT and to protect it from
overheating. These openings must not be blocked or covered.
Never place your PRODUCT on a bed, sofa, rug, or other similar
surface: on or near a radiator or heat register. This PRODUCT
should not be placed in a built-in installation such as a bookcase
or rack unless proper ventilation is provided or the manufacturer’s
instructions have been adhered to.
16. POWER SOURCES:
The PRODUCT should be operated only from the type of power
source indicated on the label. If you are not sure of the type
of power supply at your home, consult your appliance dealer
or local power company. If your PRODUCT is intended to
be operated by battery power, or other sources, refer to the
operating instructions.
17. GROUNDING OR POLARIZATION:
This PRODUCT may be equipped with either a polarized
2-wire AC line plug (a plug having one blade wider than the
other) or a 3-wire grounding type plug, a plug having a third
(grounding) pin. If you are unable to insert the plug fully into the
outlet, try reversing the plug. If the plug still fails to fit, contact
your electrician to replace your outlet. Do not defeat the safety
purpose of the polarized plug.
18. POWER-CORD PROTECTION:
Power-supply cords should be routed so that they are not likely
to be walked on or pinched by items placed upon or against
them. Pay particular attention to cords at their plug ends, at
receptacles, and the point where they exit from the unit.
19. OUTDOOR ANTENNA GROUNDING:
PRODUCT, be sure the antenna or cable system is grounded
to provide some protection against voltage surges and built-
up static charges, Section 810 of the National Electrical Code,
ANSI/NFPA No. 70-1984, provides information with respect
to proper grounding of the mast and supporting structure,
grounding of the lead-in wire and supporting structure,
grounding of the mast and supporting structure, grounding of
the lead-in wire to an antenna discharge unit, size of grounding
to conductors, location of antenna-discharge unit, connection
to grounding electrodes and requirements for the grounding
electrode. See figure below.
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250, PART H)
NEC NATIONAL ELECTRICAL CODE
ELECTRIC
SERVICE
EQUIPMENT
GROUND
CLAMP
ANTENNA
LEAD IN
WIRE
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)