Samsung HPR4252X-XAC - Manual (Page 17)

17
1
Remove the 4 screws on the back of the product.
2 Insert the screw into the plastic hanger. (See the figure below)
Fixing the TV panel to the wall attachment panel bracket
The shape of the product may vary depending on the model. (The assemblies of the plastic
hanger and the screw are the same)
3 Tighten the 4 screws in step 2 (plastic
hanger + screw
) to the rear holes of
the product.
4 Remove safety pin (#) and insert the 4
product holders into the corresponding
bracket holes (!). Then place the
product (@) so that it is firmly fixed to
the bracket. Make sure to reinsert and
tighten the safety pin (#) to securely
hold the product to the bracket.
PDP
Wall Bracket Wall
• Mount the product on the wall bracket and make sure it is properly fixed to the left and
right plastic hangers.
• Be careful when installing the product on the bracket as fingers can be caught in the holes.
• Make sure the wall bracket is securely fixed to the wall, or the product may not stay in
place after installation.
BN68-00835A-00(002~035) 4/6/05 8:19 PM Page 17