Ampro Corporation CoreModule 420 5001692A - Manual (Page 65)

CoreModule 420 Reference Manual 59
Appendix B Connector Part Numbers
These connectors are used on the CoreModule 420 and can be used to determine the mating connectors,
if you want to make your own cables.
Table B-1. Connector and Manufacture’s Part Numbers
Connector Pin Number/Pin Spacing/
Orientation Manufacturer Manufacturer’s PN
J2 – Ethernet 8-pin, 0.1”, right angle Molex Housing = 10-11-2063
Pins = 08-55-0102
J3 – Serial 1 10-pin, 0.1”, right angle Molex 10-89-1106
J4 – Floppy/
Parallel 26-pin, 0.1”, right angle T&B Ansley or
Spectra-Strip 609-2600M or
812-2622-134
J5 – Utility 10-pin, 0.1”, right angle AMP or
Molex 102387-1 or
22-55-3101
J6 – IDE 44-pin, 2mm, straight TEKA HM222BT1U-191-00
J7 – Power 10-pin, 0.1”, right angle AMP or
Molex
AMP or
Molex
Housing = 87456-5 or
22-55-2101
Contact = 87523-6 or
16-02-0103
J8 – GPIO 10-pin, 2mm, straight Adam Tech or
Samtec D2PH 2 10 SG .146/.118/.420 or
TW-05-06-G-D-420-110
J9 – Serial 2 10-pin, 0.1”, right angle Molex 10-89-1106
J10 – USB 5-pin, 0.1”, right angle Molex 22-12-2054
J11 – Video 44-pin, 2mm, right angle Adam Tech or
Astron 2PH2R44SGA
AT-PH2-44-2-1-GF
J13 – Serial 3 10-pin, 0.1”, straight Molex 15-91-3100
J14 – Serial 4 10-pin, 0.1”, straight Molex 15-91-3100