Ampro Corporation CoreModule 420 5001692A - Manual (Page 24)

Chapter 3 Hardware
18 Reference Manual CoreModule 420
CPU (U14)
The CoreModule 420 uses an embedded microprocessor operating at 133MHz, that combines a powerful
x86 core and a selection of peripheral interfaces into one chip. The STPC Atlas integrates a standard 5th
generation x86 core. It supports logic including PC/104, UIDE controllers and combines these with
standard I/O interfaces to provide a PC compatible subsystem in a single chip.
Memory
The CoreModule 420 memory consists of the following elements:
•
SDRAM
•
Flash memory
•
Bytewide socket
SDRAM Memory (U7, U8, U9, U10)
The CoreModule 420 contains four 16-bit SDRAM chips of 16MB each for a total of 64MB memory
soldered into place on the module and operating at 100MHz.
Flash Memory (U6)
A 1MB flash device is used for system BIOS on the module and 768kB is available for user code. The
Flash memory also stores system parameters (CMOS settings) for battery-less boot capability when no
battery is available.
Bytewide Socket (U5)
The CoreModule 420 has a 32-pin DIP socket on the module used as a bytewide memory socket. This
socket supports DiskOnChip devices.
A memory device installed in the bytewide socket can be used for:
•
DOC2000 (M-Systems DiskOnChip

)
•
External BIOS (BIOS recovery)
Memory Map
Table 3-1. Memory Map
Address Size Use
1 0000 0000 256kB Flash ROM (BIOS)
FFFC 0000 130,560kB Unused
F804 0000 128kB Ethernet
F802 0000 120kB Unused
F800 2000 4kB Ethernet
F800 1000 4kB USB
F800 0000 3824MB Unused
0900 0000 16MB STPC Graphics Memory
0800 0000 64MB Unused
Memory Map Table continued on next page