Alamo RX96 - Manual (Page 96)

ASSEMBLY
RX96 03/09 Assembly Section 3-12
© 2009 Alamo Group Inc.
ASSEMBL
Y
HYDRAULIC OR MANUAL LIFT - PULL & OFFSET TYPE
Attach the Spring Assembly option (Figure ASM-R-0111) to the lug on the mower deck behind the Center
Gearbox. Retain using 1 x 2-3/4 bolt and locknut. Install the Hydraulic Cylinder (Figure ASM-R-0111) or the
manual Ratchet Lift Screw 1"x 2-3/4" (Figure ASM-R-0112) between the Axle Center Lug and the Lug directly
behind the Center Gearbox. Tighten all Bolts securely.
CASTER WHEEL ASSEMBLY (Lift-Type)
Standard 4:00 x 8 caster wheel assembly
Install the two axle arm weldments (1) on the rear
axle so that the Main Beam or tube of weldment is
angled down toward ground. Space axle arm
weldment (1) so wheels will be at the desired row
spacing. Install all four bolts (3) in each axle arm
weldments and tighten bolts evenly so that space
between upper and lower clamp faces remain
approximately the same. Figure Asm-R-0303