Tongue, Axle assembly - pull type, Tongue -4 axle assembly - pull type -4 – Alamo RX96 User Manual

Page 88: Assembly, Assembl y

Text mode
Original mode

ASSEMBLY

RX96 03/09

Assembly Section 3-4

ASSEMBL

TONGUE

Attach clevis weldment (3) to tongue weldment (1) using bolt (11), and locknut (12). Then attach tongue
weldment (1) to mower deck lugs with pin (6), bushing (8), and secure with locknut (9). Make sure that jack
mount tube (5) and (4) are attached to tongue and deck lugs. Attach parking jack (15) to mount tube (5) when
in storage and (4) when in operation or transport. Note: Attach Safety Chain (27) to Tongue when in transport.
Figure Asm-R-0285.

AXLE ASSEMBLY - PULL TYPE

Attach the rear axle to the lugs on the rear of the mainframe using axle pivot pins (2), bolts (13), and locknuts
(8). Figure Asm-R-0284