Or raise mower. use protective device, Springs weak. replace springs, Improper adjustment. re-adjust slip clutch – Alamo RX96 User Manual

Page 143: Too much power for reduce ground speed and, Slip clutch. material intake, Friction facings worn. replace facings, Oil on facings. replace facings, Friction facings glazed. clean with emery cloth, Approximately 5/8, Oil level too high. lower oil level to plug

OPERATION

RX96 03/09

Operation Section 4-47

OPERA

ION

Needle Rollers have

Load too high for joint.

Check for small joint angles.

brinelled into Cup and Cross

Use protective device.
Check joint angles and phasing.

Shaft or Tube Twisted

Over-loaded.

Replace part and then slow down or

or raise Mower. Use protective device.

Toke broken at Ear Tip

Over-loaded.

Replace part.

Slip Clutch slipping

Excessive load.

Reduce speed and/or raise cutter.

excessively

Springs weak.

Replace Springs.

Improper adjustment.

Re-adjust Slip Clutch

Too much power for

Reduce ground speed and

Slip Clutch.

material intake.

Friction Facings worn.

Replace Facings.

Oil on Facings.

Replace Facings.

Friction Facings glazed.

Clean with emery cloth.

Oil blowing out Vent Plug

Flat bottomed Vent Plug

Replace with proper Vent Plug.

or shallow cavity Plug.

Cavity in Oil Plug should be

approximately 5/8".

Oil level too high.

Lower oil level to Plug.

Driveline Integral Shields

Integral Shields deformed.

Replace Shield.

rattling or not turning freely

Nylon Bearing worn.

Replace Nylon Bearing.