Samsung LTP326WX-XAC - Manual (Page 52)

51
3. Watch Menus Chapter 6.
Anynet Q & A
Problem Solution
Solution1: Connect the video cable of the device to the TV according to the
connection diagram before use.
Solution2: Check to see if the video cable is connected to the same place
now as it was at the time you selected the Connection Setting.
To re-connect the video cable to a different location, re-select the
Connection Setting and choose a device to watch.
Solution2: If the cables are connected properly, see if the video cable of the
VCR is damaged.
Solution3: If the TV is in VCR mode, see if the tape has any noise.
The device may not be able to detect the video signal if the noise
level is high.
Solution1: Connect the video cables of the VCR properly according to the
connection diagram. Then go to [ Set up ] in the Anynet
menu and select [Typical Setup] or [Customized Setup] .
(After selecting the connection settings, make sure that the
Anynet device is selected for VCR viewing in the pop-up\
window.)
Solution1: Check to see if the power cord of the device is plugged
in operly.
Solution2: Check to see if the Anynet devices are connected properly
according to the instructions.
BN68-00653H-00Eng.qxd 7/8/04 3:44 AM Page 51