Samsung LTP326WX-XAC - Manual (Page 49)

48
1. Troubleshooting Chapter 6.
Anynet Q & A
Problem Solution
Solution1 : To change the remote control to Anynet mode, be sure to
press the "MODE" button on the TV remote control to change
to TV mode first.
Can’t use Anynet.
Can’t use (name of device). Solution1 : Check to see if the power cord of the device is plugged in properly.
Can’t use in the current mode. Solution1 : The key is not supported in the current mode.
For details, see “Chapter 3. Anynet Remote Control Functions.”
Anynet operating… Solution1 : You cannot use the buttons on the remote control while the Anynet
settings are being adjusted or while switiching to another Watch
mode Try the buttons again after the application of the new Anynet
settings or the modes have been switched.
Solution1 : The device that is currently recording is not turned off when you
press the power button.
To turn a device that is currently recording off, use the device's
remote control or the button on the front of the device.
You cannot turn the device off
Solution2 : Check to see if the Anynet devices are connected properly
according to the instructions.
BN68-00653H-00Eng.qxd 7/8/04 3:44 AM Page 48