Avocent Cyclades PM IPDU - Manual (Page 32)

22 Cyclades PM IPDU Installer/Administrator/User Guide
factory_defaults
The factory_defaults command resets the unit to its factory configuration. When used with a daisy
chain, and no argument is given, this command resets all units in the chain. This command is
available to the admin user only.
Syntax
factory_defaults [|]
Arguments
Examples
To reset the factory defaults, enter:
help
The help command displays the system help message for all commands or for a single command
when specified.
NOTE: When the admin user is logged in, the help command displays all commands. When a regular user is
logged in, the help command displays only the regular user commands.
Syntax
help
Arguments
Any available command
Examples
To view the system help message for a specific command, enter the command followed by help .
To view the system help message for all commands, enter:
pm>help
no argument Resets all PM IPDUs in the daisy chain to factory default
Number of the PM IPDU in the chain
Identification string previously set by the id command
pm>factory_defaults 1
pm>syslog help