AMX ViewStat User Manual
Viewstat
Table of contents
Document Outline
- ViewStat Communicating Thermostat Operation/Reference Guide
- Table of Contents
- Product Information
- ViewStat Installation and Wiring
- Disconnecting Power to All HVAC Equipment
- Selecting the Thermostat Location
- Removing the Faceplate from the Base
- Setting the DIP Switch
- Attaching the MiniVerter to the ViewStat
- Wiring the VST-TSTAT to a VST-DIST Distribution Panel
- Mounting the Base to a Wall
- Connecting the ViewStat to AMX Control Systems
- Connecting to an Axcess Control System (via AXC-232++, AXB-EM232, or Axcent3/PRO)
- Connecting to an Axcess Master Controller via the RS232/422/485 (DB-9) Port
- Connecting to NetLinx Integrated Controllers via the RS232/422/485 (DB-9) Port
- Connecting to a NetLinx Master controller via NXC-COM card
- Connecting to a LandMark Control System
- Installing the Cat5 Suppression Ferrite
- Connecting to a NetLinx Control System
- Connecting to a Landmark Control System
- Connecting the ViewStat to the HVAC System
- Wiring the Thermostat
- Checking HVAC System Operation
- Optional HVAC Set-Up Features
- Address the Thermostats and Set Highest Address
- Wiring Diagrams
- Single-stage furnace and AC configuration.
- Two-stage furnace and two-stage AC configuration.
- Roof top unit (two-stage heat and two-stage cool) configuration.
- Boiler with AC (two transformers) configuration.
- Single-stage heat pump configuration
- Two-stage heat pump configuration.
- First- stage radiant floor heat, second-stage furnace one stage of cooling configuration.
- Support Module Installation and Wiring
- Set Up and Configuration
- Using the NetLinx Module to Program the ViewStat
- Operating the Thermostat