Removing the faceplate from the base – AMX ViewStat User Manual
Page 14
ViewStat Installation and Wiring
8
ViewStat Communicating Thermostat
Removing the Faceplate from the Base
No tools are required to disassemble the thermostat – just use your hands to pull the front panel off of the base
(FIG. 2).
While holding the base of the thermostat, apply pressure to the base of the latch with your thumb (FIG. 3).
Both sides have a latch, but it is easiest to unlatch one side at a time.
FIG. 2
Pulling the front panel off of the base
Loss of internal programs may result from static discharge to thermostat circuit board.
Touch a grounded metal object to discharge any static charge before handling the
circuit board.
FIG. 3
Location of latch on base (one latch on each side)
Press base
here