Pro-Lite ArizonaSun User Manual
Page 10
ARIZONA SUN
9
How to Set the Clock
The ArizonaSun also has the function to display the current time. Follow the procedures
below to set the clock:
[Procedures]
1. Press [Run/Stop] and then the [ESC] key.
2. The display should read: GRA, DT, CK, TM? (Graphics, Date, Clock or Timer?)
3. Press [Alt] and then [CLOCK] key. The 6 digital clock will appear on the display, and the
first digit on the left-hand side is flashing. The clock is in a format of hour-minute- seconds.
4. Press the numerical key to choose the number you want. Input each individual numbers to
set up the current time.
5. Use the DIRECTION KEY [
→] or [←] to move the inserting point to any digit to change
number if there’s a mistake been made on the clock.
6. Press [Run/Stop] to finish and store the clock made in the display. The display will appear
previous messages.
The next procedures will show you how to insert the current time into your messages:
[Procedures]
1. Press [Run/Stop] and [PROG] key.
2. Press [Alt] and then the [CLOCK] key.
3. Press [Alt] and [End] key.
4. Press [Run/Stop] key to resume display animation.
Note: You can set the clock function to be a 12-hour mode or a 24-hour mode. After setting the
clock digits, press [ESC] key once or twice to choose the 12/24-hour mode. Then, Press [CLOCK]
key to return to the CLOCK mode or press [Run/Stop] to resume display animation.
How to Set the Date
The procedure of setting the Date is similar to Clock mode.
[Procedures]
1. Press [Run/Stop] and then the [ESC] key. GRA, DT, CK TM?
2. Press the [DATE] key to enter the Date editing mode.
3. The Date format is as followed: Day-Month-Date-Year.
4. Press [
↑] or [↓] key to choose a day name.
5. Press [
→] key to move to month.
6. Press [
↑] or [↓] key to choose a month.
7. Press [
→] key to the Date selection. Use the numeric key to enter the number of current
date.
8. Follow the previous steps to set the Year.
9. For correction, use the [
→] or [←] key to move to the location of the error. Use the numeric
key to insert the correction.
10. Press [Run/Stop] key to resume display animation.