Pro-Lite PL-XPSB4014 (shown) - Manual (Page 31)

24
Sending a Message
The Send Message icon is used to transmit the message to the sign.
1. In the Message Window, type in a test message such as 'Welcome to my
message".
2. Click on the icon on the Toolbar or press "F5" to bring up the Send
Message window.
3. Click on "OK" to send your message to the sign. If your sign did not
receive your message, try sending the message again.
Configure Software
1. Go to "File" and "Set Communication"
2. Click on "OK" when your settings are complete.
Select the Com Port
from PAGE 23.
Select the Baud
Rate from PAGE 23.
Data Bits = 8
Stop Bits = 1
Parity = None
Do Not Change
These Settings.
Enter the Sign ID Number
from PAGE 23.
** Select a page to send
your message to.
** You have pages A-Z available. Each page can be used to store a
different message.