Campbell Scientific WINDSONIC 2-D Sonic Wind Sensors - Manual (Page 33)

WindSonic Two-Dimensional Sonic Anemometer
FIGURE 7-2. SDI-12 Transparent Mode on an Edlog table-based
datalogger using control port 8 and changing the SDI-12 address
from 0 to 1
7.5.3 CR200(X)-series Datalogger
• Connect a single WindSonic4 to the datalogger using Control Port
C1/SDI12 as described in Section 7.2.3, SDI-12 Wiring, and download a
datalogger program that does not contain the SDI12Recorder()
instruction.
• In the LoggerNet Toolbar, navigate to and activate the Test|Terminal
Emulator … menu. The “Terminal Emulator” window will open. In the
Select Device menu, located in the lower left hand side of the window,
select the station.
• Click on the Open Terminal button. If communications between the
datalogger and PC are successful, the red bar located in the upper left hand
side of the window will turn green.
• Press the key until the datalogger responds with the “CR200(X)>”
prompt (FIGURE 7-3).
• To query the WindSonic4 for its current SDI-12 address, press the
key, at the “CR200(X)>” prompt enter the command “SDI12>?!”, and
25