Campbell Scientific Sentek EasyAG Installation Guide v 3.0 - Manual (Page 17)

Installing EasyAG probes
Copyright © 1991 – 2003 Sent ek Pt y Lt d All rights reserved Page 14
Items required for installation
Sentek Items
EasyAG 50 Probe
Complete Description Part
Number
5 wire interface
EasyAG probe that connects to
an RT6 logger via proprietary
Sentek communication protocol
15005
Voltage interface
EasyAG probe that has a voltage
communication protocol
15009
SDI-12 interface
EasyAG probe that has an SDI-
12 communication protocol
15012
RS232 interface
EasyAG probe that has an RS232
communication protocol
15232
RS485 interface
EasyAG probe that has an RS485
communication protocol
15485
EasyAG Installation Kit
includes the following: Installation tools that, in
conjunction with the AMS soil
sampling auger, are used to
install the EasyAG 50 and
EasyAG 80 probes
70500
1 x stabilization plate The stabilization plate is designed
to minimize vibrations and
sideways movements when
hammering in the AMS Soil
Sampling Auger and EasyAG
probe to maintain the integrity of
the installation.
Not avail. as
separate
item.
1 x polyguide,
stabilization plate The polyguide holds the AMS Soil
Sampling Auger firmly within the
neck of the stabilization plate.
70505
4 x stabilization plate
pins (long) The long stabilization pins hold
the stabilization plate firmly in
place when installing into
mounded sites.
70502
4 x stabilization plate
pins (short) The short stabilization pins hold
the stabilization plate firmly in
place when installing on flat
ground.
70503
1 x EasyAG dolly The EasyAG 50 dolly is used to
hammer in the EasyAG 50 probe
plastics into the pre-drilled hole
made by the AMS Soil Sampling
Auger
70525
1 x dolly rubber The dolly rubber holds the
EasyAG 50 dolly and EasyAG 80
dolly centrally within the probe
plastics to minimize sideways
movement and vibration when
hammering in the probe
70538