Campbell Scientific CS547 Conductivity and Temperature Probe and A547 Interface - Manual (Page 6)

CS547 Conductivity and Temperature Probe and A547 Interface
2
A547
Logan, Utah
MADE IN USA
A547 INTERF
ACE
AG
SE
TEM
P
EX TEMP EX COND
DATALOGGER
SENSOR HI CO
N D
LO COND SHIELD
SHIELD
TEMP
COND EX C
ON
D
EX TEMP
FIGURE 1-1. A547 Interface and CS547 Conductivity and Temperature Probe
2. Specifications
2.1 CS547 Probe
Construction The probe housing is stainless steel
Size Probe Length: 3.7 inches (94 mm)
Diameter: 0.95 inches (24.13 mm)
Maximum Cable
Length 1000 ft. The sensor must be ordered with desired length
as cable cannot be added to existing probes.
Depth Rating Maximum 1000 feet
pH Range Solution pH of less than 3.0 or greater than 9.0 may damage
the stainless steel housing.
Electrodes Passivated 316 SS with DC isolation capacitors.
Cell Constant Individually calibrated. The cell constant (K
c
) is found on
a label near the termination of the cable.
Temp. Range of Use 0
° to 50°C.
EC Range Approx. 0.005 to 7.0 mS cm -1 .
Accuracy in KCl and Na
2
SO
4
, NaHCO
3
, and NaCl standards at
25
°C:
±5% of reading 0.44 to 7.0 mS cm -1 .
±10% of reading 0.005 to 0.44 mS cm -1 .
2.2 A547 Interface
Size Dimensions: 2.5” x .875” x 1.750
Weight: 6 oz.
Temperature Rating -15
°C to +50°C