PHASE RESEARCH 2000 Series User Manual
Page 90
SECTION 13 - PARAMETERS PROGRAMMING
13-22
PHASE RESEARCH
USER GUIDE
5.b. Press
to move cursor to the right of the percentage.
5.c. Press
or
to select the desired percentage at which the Display
will change color.
5.d. Press
to move the cursor to [%].
5.e. Press
or
to select the event to be monitored.
6. Press
to move the cursor to [FLASH AVG].
7. Press
or
to select the averaging period (HOURLY; DAYPRTS;
SHIFTS; DAILY; WEEKLY; MONTHLY; ALT). The averaging period applies
to all Remote Displays. If you select a blank value, no averages will be flashed
between events.
NOTE: Depending on the model of the Remote (one-color, two-color, or percentage),
the data will be shown either in minutes:seconds, seconds only, or percentage.
Time data will be displayed only during the hours the store is open. When
closed, only a colon (two vertical dots, i.e., :) is shown on a minutes:seconds
Display; a seconds and percentage Display is blank.