PHASE RESEARCH 2000 Series User Manual
Page 86
SECTION 13 - PARAMETERS PROGRAMMING
13-18
PHASE RESEARCH
USER GUIDE
4. Press
or
to select the report option. The Timer displays an X for
each selection.
5. Press
to move the cursor to REPORT.
6. Press
to move the cursor to [@] immediately to the right of REPORT.
7. Press
or
to select one of two options: a specified time (time=)
or a specified time increment after store closing (close+).
8. Press
to move the cursor to either [=] or [+] depending on your choice
in the previous step.
9. Press
or
to set the time for printing the automatic reports.
NOTE: You can turn the following features
–
HEADER, TARGET, PEC, AUTO
–
ON
or OFF.
10. Press
to move cursor immediately to the right of PULLOUT.
11. Press
or
to select ON or OFF.
12. Press
to move cursor to the right of FTe (Fulltime Event).
13. Press
or
to select ON (to print any events in the Timer) or OFF.
14. Press
to move cursor to the right of HEADER.
15. Press
or
to select ON (to print a Report Header on each report)
or OFF.
16. Press
to move cursor to the right of PEC (Print Each Car).