Flytec 6010/6005 - Manual (Page 8)

Operating Instruction Flytec 6005/6010 7
Altimeter Overview
Key
3 sec
Key
3 sec
Short
press
Key Direct Functions Set-Mode Ë Option-Mode Ë
1 2 3
ALT 1
ALT1
Altitude 1 starting point
set with Arrow Keys
or choose preset
1 to 5 with MEMO Key
Unit
Altitude 1
m or ft
Unit
QNH pressure
hPa or inHg
Corr
pressure sensor
correction
+/-47.9 hPa
ALT 2
ALT2
Altitude 2 starting point
set with Arrow Keys
Unit
Altitude 2
m or ft
REL/AbS
relative or
absolute mode for
Altitude 2
Clear ALT3 no Set Mode no Option Mode
Ë Only if no flight acceptance is
Altimeter 1 (ALT1)
Altimeter 1 indicates the absolute altitude above sea level.
Press the Altitude Key to alternate between displaying ALT1
(current barometric altitude) and ALT2 (reference barometric
altitude).
Set-Mode ALT1
Press the ALT1/ALT2 Key for three seconds while ALT1 is
shown in the display, to bring the instrument into ALT1 Set-
Mode. The altitude and the QNH display fields will flash,
modeindicating that they can be set; use the arrow keys to
adjust your current altitude/QNH. Note that the QNH changes
as the altitude changes, consequently if your current altitude
is unknown it can be set by setting the QNH available from
weather reporting stations or flight service. Important: ALT1
set is only available if The 6005/10 has not recognized the
beginning of a flight (flight acceptance).
Press 3 sec.
ALT1 can only be adjusted to current absolute height, and
cannot be adjusted more or less than 3,000 feet of the
current displayed height.