Acer Altos R910 Series - Manual (Page 79)

69
6 Insert the VRM into the correct VRM connector and press down
firmly (B).
7 Press the holding clips inward to lock the VRM in place.
8 Install the VRM baffle over the processor 4 core VRM, if installed.
9 Observe the post-installation instructions described on page 34.
Memory board
The memory boards that are configured in a non-redundant
configuration (including memory boards configured with spare
memory) must not be removed while the system is powered on.
Note: If you remove a memory board from the server, you must
replace it with a replacement memory board or a memory board
air baffle.
Important: Refer to the memory board installation order table
on page 158 when installing and removing memory boards.
Processor 3 VRM Processor 4 VRM