Acer Altos R910 Series - Manual (Page 64)

3 System upgrade 54
6 Install a memory board or memory board air baffle. For
instructions on how to install a memory board, refer to section
below. For instructions to install a memory board air baffle, refer
to “Installing a memory board air baffle” on page 43.
7 Observe the post-installation instructions described on page 34.
Installing a hot-plug memory board
1 Observe the ESD precautions described on page 33.
2 Locate an empty memory board slot.
3 If necessary, remove the memory board air baffle. Perform
instructions described in “Removing a memory board air baffle”
on page 42.
4 Add or replace memory DIMMs as needed. For instructions, see
“Installing DIMMs” on page 73 and “Removing DIMMs” on
page 75.
5 Ensure the handle on the memory board is in the open position.
6 Align the board edges with the card guides and slide the memory
board into the memory board slot (A).
7 Push the handle down until it is in the locked position (B).
8 Observe the post-installation instructions described on page 34.