Siemens GS36DPI20 - Manual (Page 43)

en
43
Fault Possible cause Remedial action
The ice maker does not
make enough ice or the ice is
deformed.
The appliance or ice maker
has only just been switched
on.
Approx. 24 hours is needed until ice
production starts.
A lot of ice has been taken. Approx. 24 hours is needed until the ice cube
container is filled again.
Low water pressure. Connect the appliance to the stipulated water
pressure only (see chapter “Connecting
the appliance”, section “Water connection”).
The freezer compartment
temperature is too warm.
Set temperature colder.
Screen on the water supply
is dirty.
Clean the screen.
Ice dispenser does not
function.
The “lock” and “on/off”
buttons flash.
Water has escaped from the
pipe system.
The integrated AquaStop
system has interrupted the
water supply.
Switch off the water supply and inform
customer service (see chapter entitled Alarm
function).
Ice dispenser does not
function.
The “lock” button is still lit
even after it has been
pressed for three seconds.
Appliance door is not closed. Close appliance door properly.
Ice dispenser does not
function.
No ice cubes are dispensed.
Ice maker is empty. All the
ice cubes have been
dispensed.
Wait for more ice cubes to be produced.