Siemens GS36DPI20 - Manual (Page 42)

en
42
Ice maker
Fault Possible cause Remedial action
Freezer compartment door
was open for a long time;
temperature is no longer
reached.
The evaporator (refrigeration
generator) in the NoFrost
system is covered in thick ice
and can no
longer be defrosted fully
automatically.
To defrost the evaporator, remove the frozen
food with the compartments, insulate well
and store in a cool location.
Switch off the appliance and move it away
from the wall. Leave the appliance door open.
After approx. 20 min. the condensation begins
to run into the evaporation pan,
at the rear of the appliance. Fig. '
To prevent the evaporation pan
from overflowing in this case,
mop up the condensation with a sponge.
The evaporator is defrosted when the water
stops running into the evaporation pan. Clean
the interior. Switch the appliance
back on again.
Appliance is not cooling,
temperature display and light
are lit.
Showroom mode is
switched on.
Hold down alarm button, Fig "/5, for
10 seconds until an acknowledgement signal
sounds.
After a short time check whether your
appliance is cooling.
Fault Possible cause Remedial action
The ice maker doesn’t work. Ice maker is not connected
to the power supply.
Call the customer service.
The ice maker is switched
off.
Switch on the ice maker (see “Ice maker”).
Ice maker is not receiving
any fresh water.
Ensure that the water has been connected
properly.
The freezer compartment
temperature is too warm.
Check freezer compartment temperature and,
if required, set slightly colder.
Supply hose is kinked or
crushed. Fig. (
Ensure that the supply hose is installed
correctly.