Aalborg PWE Digital - Manual (Page 80)

75
INDEX NAME DATA TYPE NOTES
68 FlowTbl[3].FlowPFS float Flow Linearizer Index 3 PFS [0.0 – 1.0]
69 FlowTbl[3].LinCounts uint Flow Linearizer Index 3 Counts
70 FlowTbl[4].FlowPFS float Flow Linearizer Index 4 PFS [0.0 – 1.0]
71 FlowTbl[4].LinCounts uint Flow Linearizer Index 4 Counts
72 FlowTbl[5].FlowPFS float Flow Linearizer Index 5 PFS [0.0 – 1.0]
73 FlowTbl[5].LinCounts uint Flow Linearizer Index 5 Counts
74 FlowTbl[6].FlowPFS float Flow Linearizer Index 6 PFS [0.0 – 1.0]
75 FlowTbl[6].LinCounts uint Flow Linearizer Index 6 Counts
76 FlowTbl[7].FlowPFS float Flow Linearizer Index 7 PFS [0.0 – 1.0]
77 FlowTbl[7].LinCounts uint Flow Linearizer Index 7 Counts
78 FlowTbl[8].FlowPFS float Flow Linearizer Index 8 PFS [0.0 – 1.0]
79 FlowTbl[8].LinCounts uint Flow Linearizer Index 8 Counts
80 FlowTbl[9].FlowPFS float Flow Linearizer Index 9 PFS [0.0 – 1.0]
81 FlowTbl[9].LinCounts uint Flow Linearizer Index 9 Counts
82 FlowTbl[10].FlowPFS float Flow Linearizer Index 10 PFS [0.0 – 1.0]
83 FlowTbl[10].LinCounts uint Flow Linearizer Index 10 Counts
84 T_InScale float Temperature RTD input Scale**
85 T_InOffset float Temperature RTD input Offset**
86 T_Mode float Reserved**
87 DiagEventMask uint
Mask for Diagnostic Events: Clear bit-> mask corre
sponding event. Default mask is 0xFFFFh
88 FlowLinearizer uint Flow Linearizer (0-Disabled, 1-Enabled)
89 T_AlarmMode uint Temp. Alarm Mode (0=Disabled, 1=Enabled)**
90 T_AlarmDelay uint Delay in seconds 0-3600 for Tem.Alarm action**
91 T_AlarmLatch uint Temp Alarm Latch 0-3**
92 T_LowAlarm_C float Low Temperature Alarm in %FS [-.1-1]**
93 T_HiAlarm_C float High Temperature Alarm in %FS [-.1-1]**
94 ReservedF3 float Reserved
95 FluidName[20] char[20] Name of the Liquid used for Calibration
96 CalibratedBy[20] char[20] Name of person, meter was calibrated by
97 CalibratedAt[20] char[20] Name of the Calibration Lab
98 DateCalibrated[12] char[12] Calibration date
99 DateCalibrationDue[12] char[12] Date calibration due
100 UserTagName char[20] User Defined Device Tag Name or Number
101 EEMagicNumber uint Number used to verify EEPROM integrity
** Not supported in some hardware configurations