MagTek iDynamo MagneSafe V5 - Manual (Page 34)

iDynamo MagneSafe V5 Communication Manual
28
Send Encryption Counter Property
Property ID: 0x30
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 0x00 (don’t send Encryption Counter)
Description: This property is used to designate whether or not the Encryption Counter is
sent as part of a keyboard message. If the property is set to 0x00, neither the
Encryption Counter nor the field separator will be sent. If the property is set
to 0x01, the Encryption Counter is sent as the field immediately following the
DUKPT Serial Number in a swipe message.
NOTE: If this property is set to 0x01 and the Format Code is currently
“0000”, the Format Code will be changed to “0001”.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled for these changes to take effect.
Mask Other Cards Property
Property ID: 0x31
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 0x00 (Don’t Mask Other cards)
Description: This property is used to designate whether or not the cards which do not
decode as ISO/ABA (Financial) or AAMVA (Driver License) cards should be
sent with their data masked or in the clear. The default state is to send the
data in the clear (0x00). If this property is set to 0x01, the track(s) will be sent
with a ‘0’ for each byte of encoded data read.
This property is stored in non-volatile memory, so it will persist when the unit
is power cycled. When this property is changed, the unit must be reset (see
Command Number 2) or power cycled for these changes to take effect.
Send Clear AAMVA Card Data Property
Property ID: 0x34
Property Type: Byte
Length: 1 byte
Get Property: Yes
Set Property: Yes
Default Value: 0x00
Description: This property is used to control how to send out AAMVA card data.