MagTek iDynamo - Manual (Page 12)

3 - Operation
iDynamo| MagneSafe Secure Card Reader Authenticator | Technical Reference Manual
Page 12
5) Select the device’s entry on the “About” page to show the device’s properties page. It should be
similar to Figure 3-1.
Figure 3-1 - iDynamo Properties Page
3.2 How to Set Up Charging and Synchronization
iDynamo is equipped with a pass-through Micro-USB port which allows the connected iOS device to
continue charging and synchronizing* while iDynamo is connected.
To set up pass-through charging and synchronization*, follow these steps:
1) Disconnect iDynamo from the iOS device.
2) If charging and synchronizing* using a computer: Connect the iOS device directly to the computer’s
high-power USB port (2A @ 5V) using the iOS device’s original cable, and test to make sure the iOS
device charges and synchronizes* correctly.
1) If charging using an Apple-supplied or third-party charger designed for the device: Connect the iOS
device directly to the charger using iOS device’s original cable, and test to make sure the iOS device
charges correctly.
3) Disconnect the charging cable from the iOS device.
4) Connect iDynamo to the iOS device as described in section 2 Installation.
5) Connect the charging cable to iDynamo’s pass-through Micro-USB port.
* Note that when iDynamo is connected to the iOS device using the Lightning connector, the iOS device
can only charge through the Micro-USB port; it can not synchronize.