MagTek InSpec 9000-2005 - Manual (Page 34)

InSpec 9000-2005 Encoded Card Tester
24
Amplitude, Average Bit Size, and Start Sentinel values must be manually transcribed for
all three tracks.
4.
Repeat the above until 10 reads of the selected test card are completed.
5.
From the “View” menu, click on “setup”. Click on “Print”, and then click on “Close”.
Again, if a printer is not available, transcribe the information manually.
6.
You will need to send in the results of the10 reads of the selected test card, either in the
printout form or in the manually transcribed form, the “setup” information obtained in # 5
above , and the test card that was read.
Contact your local sales representative for the proper procedure for obtaining MagTek Technical
Support. If calibration is required, MagTek will use the above information to either produce a
new setup card for “in-field” calibration or to recommend service options.